Stratux AHRS Upgrade Kit

  • Sale
  • $24.00


Intro

Do you love your current Stratux setup and are looking for an easy way to upgrade your unit to gain even more features? Then look no further! Save money by buying these together instead of individually.  

With this upgrade kit you get:-

  • 1 X AHRS Board + Fan Controller Board
  • 1 X Pre-Flashed Micro SD Card

We now simply use the best and most robust micro SD cards, as we know that you would rather be flying than messing around with software to reimage your SD cards. It may cost us more but that's the cost of quality. Skip the 2gb cards and get one that will last.

Installation:-

V1 Users

Connect the board and install the new SD card as depicted below. You do not have to remove the computer. The new SD card goes in the bottom of the unit; simply pull out the new one. You should see the colored side of the card as you push it in.

When reinstalling the fan connectors make sure to orientate the fan connector correctly. Please note that the fan won't start to work until the Stratux is fully booted. The fan pulsing on is now a good indication of when you should see the Stratux network show up on your wifi list.

Lastly, the new light indications are as follows:

Booting:-

Solid red light until fully booted and the fan should pulse briefly. 

Both lights are solid in color. You should see the Stratux wifi. 

Shutting down:-

Flashing green light pulse accompanied by a solid red light and the fan shutting off - if on. Once you see the green light turn solid again, and the fan stop, you can safely unplug the power after about 45 secs.

The pictures below are to just show what pins the module goes onto. You do not have to remove the computer. It should slip on the pins if you gently lift the lid and unplug the fan. In the picture above the left forward facing pin is for the positive (+) fan connector that is red. Therefore, the right side is for the negative (-) fan connector that is black.

Lastly, watch this video for how to calibrate the AHRS board.

*****For All Other Users*****

Simply follow the pictures below for the proper placement of the board AHRS Board. It should be on the last set of pins on the Raspberry Pi. 

Lastly, watch this video for how to calibrate the AHRS board.

Future Software Updates & Manuals

Please go to this page for more info:- 

https://www.everlastconcepts.com/pages/stratux-documentation-manuals

 


Customer Reviews

Based on 3 reviews Write a review